Setting up a remote control whrere does the yellow wire go

SETTING UP A REMOTE CONTROL WHRERE DOES THE YELLOW WIRE GO PROFESSIONAL

Multiple designations like W and O/B, it will be labeled as W and O/B and not just one or theДЄfter you have removed and labeled all wires you can unscrew, remove the old thermostat wall Using the photos that you took, remove each wire one at time and label it. The most common configuration isДЇive wires, however you could see as few as two, and as many as ten.ДЄny wire that is present, but not connected to a terminal you will want to make a note of, but you What you should typically see is 18 - gauge solid core wire. G is compatible, but not G1,G2,and/or G3. If you see wires connected to terminals labeled G1,G2,G3, you will need a thermostat capable ofД¬ontrolling multiple fan speeds, none of our retail thermostats are compatible with this system Requires a line voltage thermostat and is not compatible with low voltage thermostats If you see thick, black or red wires then you have a line voltage system. If you see terminals labeled A B C, or 1 2 3 then your new thermostat may not be directlyД¬ompatible, as your system requires a communicating thermostat. The terminal markings are clearly visible. When taking the picture, please make sure that The next step is to take a picture of your wiring. However, some lift from the bottom and lever off, and others have a locking tab. Next, remove your existing thermostat from the wall plate. If you have a digital thermostat that has a The system turn on within 5 minutes, the power is off. Your existing thermostat so that your system starts heating or cooling. To make sure that your system is off, change the temperature on To protect your equipment, turn off the power at the breaker box or switch that controls your Please follow the below guide for the basic wiring walkthrough:

SETTING UP A REMOTE CONTROL WHRERE DOES THE YELLOW WIRE GO PROFESSIONAL

Professional HVAC Contractor to continue. If you have a dual-fuel system, or are unsure, it is recommended that you contact a Pump for the first 1 or 2 stages of heating and use a gas or oil furnace for backup / emergency *Trade model thermostats are required to operate 'dual-fuel' systems (systems that use a heat O/B вЂ“ Reversing valve for Heat Pump systems U вЂ“ Humidifier, Dehumidifier, or Ventilator control See the diagram below for what each wire controls on your system: The thermostat uses 1 wire to control each of your HVAC systemвЂ™s primary functions, such as For typical wiring examples, and for clarification of what types of systems your thermostat works with, please consult your owners/install guide. If you do not know the terminal that each wire connects to, it may be necessary to go to the HVAC system and look at the designations on the control board.

When wiring, each wire should be identified by what terminal(s) it connects to, never by color.

*There is no standard for which color wire controls each function.

Setting up a remote control whrere does the yellow wire go